Especificaciones
- Color
- White
- Material
- Plastic
- Estilo
- wall cord hider
- Dimensiones
- 157"L x 0.95"W
- Indoor Outdoor Usage
- Indoor, Outdoor
- Number of Pieces
- 1
- Number of Packs
- 1
- Unit Count
- 13.1 Feet
- Fabricante
- delamu
- Built-In Media
- Cord Hider
- Peso
- 0.58 kg
- Model Number
- CC01
- Mfr Part Number
- CC01
- Garantía
- 1 Year
- Enclosure Material
- Plastic
- Item Dimensions L x W
- 157"L x 0.95"W
- Installation Type
- Screw In, Self Adhesive
- Style Name
- wall cord hider
Ver todas las especificacionesVer menos⌄
Calificaciones
4,5
★★★★★41.954 calificaciones
Las calificaciones provienen de Amazon.com.
CChristian Cribbs
12 de julio de 2026
Easy and safe
Perfect and would buy over and over again durable and very versatile. The size is perfect and the thickness is perfect. Easy to use discreet and hide those chords from baby fingers
Just get this already! Do it!
These little tubes just stick to the wall, can’t fit more than 2 cables but it’s easy to run the cables in and click the cover on - I’m not sure you can even see them in this photo, thats how great they are! Here we put two rows of them side by side since we have 4 cables hanging in all. Such a cheap little thing makes such a HUGE DIFFERENCE.
Easy & Cheap, But Renters Beware
This was a relatively cheap & easy solution that did a pretty good job at covering my TV cables. I was able to cut it to size relatively easily.It fit ~ 2 thick HDMI cables & a thin power cable. I’m not sure that I could’ve fit any more inside of it successfully.My one warning is that the adhesive provided is *not* renter friendly. When I removed it, I had big spots where it leaked off my wall. If recommend using a different adhesive if you’re a renter (maybe command strips).
KKimberly W.
26 de abril de 2026
Great product!
As crazy as it sounds, we DIYers decided to add additional lights to our travel trailer by running wiring from the lower taillight, to the inside of our TT, up the wall, and outside to add some much needed exterior rear lights.These were easy to use and look terrific. It does take some degree of trial and error. I felt that installing EACH small piece with the double sided tape was the best way to go, butting each up to the vertical penciled line (Use Mr. Clean Magic Eraser to remove markings afterwarrds.) You will get only ONE chance to apply each segment to your wall, so take your time, install one segment at a time as the double sided tape is unforgiving.We staggered each top cap so that the seam (where each of the bases met) were covered with one cap, i.e., the top and bottom seams did not match up. In other words, while the bottom cap was at the top of the ceiling, when it was all done, the top cap was about one inch lower from the s=ceiling and then we used one of the one inch caps at the top. While it shows you sliding the cap on, when it comes to the bottome, you're not able to do that, so you can just given it a whack and pop it on. Make certain to secure the entire length, so multiple whacks will be needed! LOL (This just gives you a more secure fit, especially in a TT when the road can cause some movement.)It came out beautifully and we're thrilled to death.As we weren't certain how thik the wires would be, we ordered two different sizes and returned the one not needed.